MarauderMNGR is a console / UI for the WiFi marauder, it allows you to use Marauder without a Flipper Zero or screen. It connects to your phone using its own WiFi. This has a couple of benefits over using a TFT display or a Flipper Zero, It's less suspicious in a public space, less bulky, easier to use, and way faster to type on compared to a Flipper.
The UI consist of a text box which displays all incoming serial data (up to 30 lines then the old ones get cut off), a text box to input commands, and below that are quick action buttons for prewritten commands.
- ESP32 X2
- 4 JUMPER WIRES
- EXTERNAL ANTENNAS (IF SUPPORTED)
- COMPUTER TO FLASH THE ESP'S
To get from a pile of stuff to a working product, do this:
- Find a suitable cable for your ESP to connect to your PC, some cables don't transfer data so you may need to try a couple.
- Connect the ESP to your PC (don't use a USB hub)
- Check the USB controller on your ESP (little black square or rectangle with lots of pins)
- Install the suitable driver according to the model: CP2102 or CH340/CH341
- The ESP should now get recognized as some kind of 'USB to UART' bridge in Device Manager under 'Ports (COM & LPT)'.
- Open https://fzeeflasher.com/
- Start holding down the BOOT or B button on your ESP
- Click CONNECT and select your ESP. (while still holding down the BOOT button)
- Now select ESP32-WROOM in 'Select Model'
- Select LATEST and MARAUDER
- Now press PROGRAM
- Wait for the flashing process finish and now you can disconnect the ESP. I suggest marking the ESP with a pen so you know where Marauder is flashed.
- 5V-5V
- GND-GND
- RX-TX
- TX-RX
